SEATING TENTS

8%

Seventh-day Adventist Publishing Association · Battle Creek, Mich. · May 8, 1883

FromReview and Herald, Vol. 60, No. 19.

Read the full edition

SEATING TENTS.

BY ELD. I. D. VAN HORN.
HAVING been solicited to write something on this point, I submit the following. For the past ten years, I have usually seated tents for public meetings in this manner:—
1. Locate the stand, and build according to the taste of those who use it; generally a platform, 6x8 feet, with a small table, is sufficient.
2. Get for seats, boards one inch thick, one foot wide, and sixteen feet long. A few shorter may be needed. For backs, get fence-boards same length as the seats, and both backs and seats should be planed.
3. Get stakes for seats instead of risers, eight for each seat. These should be from 22 to 28 inches long, according as the ground is hard or soft, and about 1¼ inches square. Get caps for the stakes, one for each pair, 1 foot long and 1¼ inches wide. A board can be sawed up and split the desired size for these.
4. Lay out the ground, beginning with the aisle or aisles, and lay a fence-board along it. There will be four bearings under each seat, so lay three more fence-boards along on the ground where the bearings come. These boards only serve as guides to drive the stakes in a line.
5. Lay the seats across these boards, the first the width of the seat nearer the stand than is wanted when it is up. Then space them the desired distance apart,—generally 27 inches for close seating, or 30 inches if there be plenty of room, measuring from the front edge of each seat.
6. Get a measure 13 inches long, and drive the two stakes at each end of the seat (about one foot from the end), so they will stand above the fence-board just the height of this measure. In driving the two pairs of stakes near the middle of the seat, some one should sight across to get them level with the ends. Where the ground is uneven, make the seat level by varying the height of the stakes.
7. Nail on the caps with eight-penny nails, and drive each nail so as to leave the head of it just above the surface of the cap. This will hold the seat from moving easily. See that the stakes for each seat are in line, and the caps when nailed on are level, so the seat will lie firmly.
8. To make backs to the seats, get stakes, either round or made of 2x3 sawed stuff, 3½ to 4 feet long, and three for each seat. Drive one near each end and one in the middle, with the desired slant back, and low enough that when the fence-board is nailed on for a back, the top edge will be 16 inches above the seat.
In seating a tent as above described, we use only one-half as much lumber as when risers are used. Some will say, This is more work than to seat in the old way. Yes, a little more; but there is the satisfaction of having the tent seated without risers, and each seat, being strong and independent, gives opportunity to pass among the people with perfect ease. And when the congregation is coming in, there is no hesitation to move to the center to give room for others. And again, when meeting is out, there is no jumping up on the seats, as is always the case when seated with risers.