HOW AN OCEAN CABLE IS MADE.
At an enormous factory on the banks of the Thames, a few miles below London, the growth of the cable may be traced through shop after shop, machine after machine. The foundation of all is the conductor, a strand of seven fine copper wires. This slender copper cord is first hauled through a mass of sticky, black compound, which causes the thin coating of gutta-percha, applied by the next machine, to adhere to it perfectly, and prevents the retention of any bubbles of air in the interstices between the strands, or between the conductor and the gutta-percha envelope. One envelope is not sufficient, however; but the full thickness of insulating material has to be attained by four more alternate coatings of sticky compound and plastic gutta-percha. The conductor is now insulated, and has developed into “core.” The core is then coiled into tanks filled with water, and tested, in order to ascertain whether it is electrically perfect; that is, that there is no undue leakage of electricity through the gutta-percha insulating envelope. These tests are made from the testing-room, replete with beautiful and elaborate apparatus, by which measurements finer and more accurate than those even of the most delicate chemical balance may be made. Every foot of core is tested with these instruments, both before and after being made up into a cable; and careful records are preserved. After all the core has been tested and passed, the manufacture of the cable goes on. The core travels through another set of machines, which first wrap it with a thick serving of tarred jute, and then with a compact armoring of steel wires of various thicknesses, according to the depth of the water in which the cable is to be laid. Above the armoring, in order to preserve the iron from rust as long as possible, is applied a covering of stout canvas tape, thoroughly impregnated with a pitch-like compound; and sometimes the iron wires composing the armor are separately covered with Russian hemp, as an additional preservative against corrosion.—Scribner’s Magazine.