AdventAI

GLASS

By F. A. Parker

From The Youth’s Instructor, Vol. 30, No. 24., June 14, 1882

How many of the INSTRUCTOR family can describe the process of blowing common window-glass? Not many, I presume, though some might do it far better than I can. Not long ago, in company with some friends, I paid a visit to the Glass Works, at Syracuse, N. Y. The first room we entered was the “blowing room.” Here were two great furnaces having a small door in each. In these furnaces is a very hot fire. Above this is what appears to be a small lake of liquid fire, which heaves and boils like a great pot. This is molten glass. At every furnace door there are two workmen; the “blower” and his assistant. They are supplied with a number of iron tubes, about four feet long, with a mouth-piece at one end. All being in readiness, the assistant takes one of the iron tubes, puts a mask over his face to keep the heat from burning him, opens the furnace door, and thrusts one end of the tube into the heaving, boiling, red-hot glass. As he pulls the tube out, a little ball of glass sticks to the end of it. He lets it cool a few moments, and again thrusts it into the molten glass. As he draws it out again, the ball on the tube is larger. He repeats the operation until the ball is large enough to suit him. He now takes it to a large tub of water near by, lays it across the top of the tub, and pours water over the tube to cool it.

It is now ready for the “blower.” He receives it and begins to blow very hard through the tube, at the same time turning it around in a hollow stone mold, to give it the right shape. As he blows, the ball begins to expand, and soon grows very large. Having formed it in the mold to suit him, he takes it to the edge of a platform, and swings it to and fro in front of him, like a pendulum, blowing through the tube all the while. This motion makes the glass lengthen out, and it soon grows into a hollow cylinder, five or six feet long, and a foot or more in diameter. This he puts on a rack made to receive it, breaks off his tube, and leaves it to get cold.

But it is not finished yet by any means: we do not make windows out of round cylinders, do we? A workman takes a cylinder in hand, and draws a straight line along one side from end to end, with a diamond. He then hits it a careful tap with his instrument, and the cylinder lies there with one side split open from end to end. It is now taken to another room, where there is another great furnace with a large turn-table inside of it. A cylinder is placed on this table with the split side up, and swung around over a hot fire. As it heats up, its sides begin to fall over, and presently it lies flat on the table. It is now swung back to the door, and after cooling a few moments, is taken out in broad, flat sheets, ready to cut up into window panes.

F. A. PARKER.