SOME THINGS ABOUT IRON

9%

S. D. A. Publishing Association · Battle Creek, Mich. · Jan 20, 1886

FromThe Youth’s Instructor, Vol. 34, No. 3.

Read the full edition

SOME THINGS ABOUT IRON.

It is frequently said that iron is worth more to the world than all the other metals; and when one thinks of the various uses to which iron is put, the statement seems true. Fortunately for man, Providence has kindly furnished a supply equal to the demand in nearly every part of the earth. Iron ore is found in large deposits; and one of the component parts of rocks, the soil, and the natural streams and bodies of water, is iron.
Iron is also found in the ashes of plants, and in the blood of animals. The blood of a full-grown man contains only about enough to make a ten-penny nail, yet it is sufficient to give energy to the man.
The elements of this metal are iron and carbon; and the amount of carbon it contains determines whether it is pig iron, cast iron, steel, or wrought iron; pig iron having the most carbon, and wrought iron the least.
When the ore is dug from the earth, it contains more or less clay, or other impurities, and is converted into metallic iron by one of two different processes. One, known as the “direct process,” used by the ancients, and still in use in many parts of the world, was to convert it at once into wrought iron. This is much the more expensive process, but it yields the best iron. With some changes and improvements, this method is still employed in Europe and the United States.
But the common method, known as the “indirect process,” is to first convert it into pig iron, which is done something as follows: “A tall blast furnace is made, which is lined with fire-brick, and at the bottom of which are pipes for forcing in hot air. The furnace is filled with lime-stone, coal, and iron ore in alternate layers, and the fire lighted. The melted iron runs to the bottom, where it is drawn off into channels cut in the sand on the floor of the furnace.” The rough pieces thus formed are called “pigs,” and these are, by certain other processes, converted into malleable iron, steel, etc. You who have been in a furnace or foundry have no doubt seen pig iron.
Malleable iron is made by burning the carbon from cast iron in a current of heated air in a puddling or reverberatory furnace,—that is, a furnace which is so constructed that the flame in passing from the fire-chamber to the chimney, is reflected back upon the mass which is being heated. During this process the melted iron is kept in constant motion by means of long sticks called “puddling sticks.” When the metal acquires a white heat, it is taken out and beaten under a trip-hammer, and afterward passed under grooved rollers. It is now malleable, and “may be beaten into leaves so thin they may be used for writing paper; six hundred leaves being only half an inch in thickness.”
Wrought iron is the purest form of the metal. It is soft, very tenacious, and when brought to great heat, may be welded, or perfectly joined together. It is sometimes beaten into bars known as “bar iron or merchant-bars.”
The cost of iron depends upon the amount of labor bestowed upon it. A pound may be worth only a few cents; while the same quantity may be worth thousands of dollars. According to a table prepared by J. Dorman Steele, Ph. D., a pound of good iron is worth four cents; when made into inch screws, one pound is worth $1.00; made into steel wire, $3-7.; sewing needles, $14.; fish hooks, $20-50.; jewel screws for watches, $3,500., and hair springs for American watches, $16,000.
It may seem to you like a big price for watch springs; but it is not the mainspring that is meant, but the little fine hair-spring which gives motion to the balance wheel. These springs are very expensive, and they are so fine that it requires very, very many to make a pound.
At another time we may give you some facts about steel.