AdventAI

HOW COMBS ARE MADE.

By Dudley Marvin Canright

From The Youth’s Instructor, Vol. 33, No. 25., July 8, 1885

The other day I went to Clinton, Mass., to visit the comb factory of Bartlett and Co., who employ about sixty hands. One of the hands was kindly permitted to show us how they made the combs.

The combs are made out of the horns of cattle—just such horns as you see on the cows and oxen at home. Here they had them by the wagon load; some were little, some were big. I brought home one nearly two feet long. Some are straight, but most of them are very crooked. These horns they gather up from all parts of the country where cattle are killed for beef. Some come from South America, from Texas, and from the West. These horns, you know, are hollow, just like a tin horn or a bottle. They are composed of a substance just about like your finger nail, only very much thicker and harder. This factory daily uses from three thousand to five thousand horns. Every particle is used in some way; not a bit is wasted.

First they take the horn, and saw off the little end, which is too small for combs. Perhaps this end will be three or four inches long. This tip is sold to other factories, where it is made up into knife handles, stems to pipes, and such things. The horn is now sawed in two on one side lengthwise, so that it can be made to open out flat. It is next placed in hot water, till it becomes soft, like a piece of sole leather. Then it is put through a machine which rolls it out flat. This piece is next pressed between two hot irons, so that it will remain flat. When it is boiled only in water, it retains its natural white color, and makes the toughest and best combs. That boiled in oil looks the best, as this boiling gives it different shades. Sometimes it gets burned in this process, and then the combs made from it are brittle, and break easily.

Another person now takes these pieces, and saws them up into smaller pieces, the size of the different combs. The smaller pieces make the fine combs, and the larger ones are used to make the coarser combs. Then they are passed to another man, who runs them through a machine, shaving them on both sides, so that they will be smooth, and of the same thickness. Now a man takes them, and cuts teeth on them with very fine saws. This is all done by machinery. Then they are passed to a man who lays them on a wheel covered with sand-paper; this rounds the back, and sharpens the teeth. Then they are passed to the next man, who scours them with wet ashes. Then another person takes them, and puts them into a machine that sets the large outside teeth straight. These pieces of horn are soft and pliable, so that they will bend like leather strips; you could tie them into knots. Of course they have to be dried straight, or they would be twisted in all shapes.

The next thing is to polish them very bright. This is done by holding them on a swiftly-revolving wheel made of cotton cloth. You would not suppose that the wheel could polish anything, but it does; it makes them shine nicely.

Now the combs are sent to the packing room, where they are put up in little bunches ready to ship. So you see that from the time the horn is taken from the old cow’s head, till it is ready to use on your head, it is quite a process to make a simple little comb. The shavings and fine dust, gathered from making these combs, are sold to gardeners, to enrich their ground.

A comb factory is not a very pleasant place to work in. The packing room is the nicest. Here the work is done by women. D. M. CANRIGHT.