In former days it took twelve or fourteen men to make a pin—that is, there were twelve to fourteen processes in its manufacture, each of which was performed separately and by a different hand. Now a single machine turns out a stream of pins at the rate of two hundred a minute, all ready to be finished. The wire is prepared by drawing it from a large coil on a revolving drum, through a hole the size of the pin wanted. The coil, wound on another drum, is then suspended at the end of a machine.
The wire passes into the machine through a hole and a series of iron pegs which keep it in place and strengthen it. A pair of pincers, moving back and forth, pull it along, and thrust the end through a hole in a small iron plate, on the further side of which a little hammer beats a tattoo on the end of the wire, and so forms the head of the pin. Next a knife descends, and cuts off the pin to the proper length. The pin falls into a groove, or slot, through which the heads cannot pass, and is thus suspended so that the lower or point end is exposed to the action of a cylindrical file, which has both a revolving and a lateral motion.
By the time the pin has passed this file, it has a smooth, sharp point, and is a complete pin so far as shape is concerned. These processes are all performed with such rapidity that the pins fall in a constant stream from the end of the machine. They are next put in quantities into revolving barrels, which are turned until the pins are scoured and cleaned. Next they are boiled in an acid, in which a fine powder of tin has been put, and they emerge from this bath white and shining with their new tin coat.
Then they are dried in sawdust, again shaken in barrels, and dusted. The machine which sticks the pins upon the papers on which they are sold is very ingenious and simple in its details, but too complicated for brief description. The machine crimps the paper and holds it, while the pins are brought up in long rows, a whole row being stuck on at one push of a lever.—Good Housekeeping.