THE NEW MAXIM GUN OF SOLID STEEL.
Mr. Maxim, whose versatile genius is just now displaying its power in the two widely different fields of aeronautics and heavy rifled ordnance, has lately produced a five-sevenths-inch forty-five pounder gun that promises to revolutionize the art of gun manufacture. He proposes to manufacture guns from one solid integral forging, and thereby supersede the present expensive and tedious system of “building up.” It is well known that the present “built-up” gun consists of an inner core, or tube, which extends the full length of the gun, over which are shrunk successively a series of concentric “jackets,” or outer tubes. This is done in order that the whole mass of metal in the thickness of the gun may be thrown into a state of tension and may be ready to receive and resist instantaneously the bursting strain that is set up at the moment of firing. Were it not for this initial tension, the bursting effect of the charge would all be thrown upon the layer of metal that was next the bore, which would be ruptured before the next outlying mass of metal could assist in resisting the strain. In the built-up gun, as a result of the initial tension, every particle of metal from the center to the circumference is firmly gripping the bore; and the shock of discharge is felt and resisted instantaneously by the whole mass of the gun. In the built-up gun, the work of carefully boring out and shrinking on the jackets is tedious and costly. Mr. Maxim saves this large item of expense. In his system the forging is roughly turned, and then annealed in a slow furnace. It is next carefully turned, smooth bored, and rifled. It is next mounted vertically in a special furnace, and rotated slowly, and a current of coal gas is forced through the bore. The carbon in the gas combines with the steel of the bore, hardening it, and improving the quality of the steel. “When the gun was red hot,” says Mr. Maxim, “the coal gas was shut off, and a very large stream of cold oil, under high pressure, was forced through the bore.” This cooled the bore, and the inside shrank to its finished dimensions. The outside body of the gun now gradually shrank upon the cooled interior portion, and was thus thrown into a state of high tension. It was found that the metal of the bore was compressed two hundredths of an inch. In the firing tests, a forty-five-pound projectile was fired with a muzzle velocity of twenty-two hundred feet and a pressure of fifteen tons to the square inch. In the later proof charges, a pressure of twenty-two and one-half tons to the inch was reached. The guns stood the test excellently. One of them was two thousandths of an inch smaller after firing than before, showing that the enormous outside tension of the gun, assisted by the concussion of the discharge, actually compressed the bore to a smaller diameter. If such guns can be made without any undetected flaws in the metal, it is evident that heavy ordnance can henceforth be manufactured in half the time and at half the expense of the present built-up system.—Scientific American.