AdventAI

BUILDING A COTTAGE.

By W. K. Loughborough

From The Youth’s Instructor, Vol. 47, No. 32., August 10, 1899

The Pitch of the Roof.

BEFORE we build, we must decide what pitch we will give the roof of the house. As I said regarding the window-sill, by pitch we mean the slant of the roof. The pitch varies, in different houses, according to the fancy of the builder. The most common style of roof at present is one-half pitch. A few years ago it was one fourth. I have seen roofs of one fifth, and even of one sixth, pitch; but that makes too flat a roof, as in time of an ice-storm, when the ice freezes at the butt of the shingle, it will back water and leak. One third pitch is good where a person does not care for a steeper one.

To find the pitch of a roof, we will take Fig. 1 for the building. Draw a line from a to b, calling it sixteen feet. Find the center at c, which is eight feet. Draw a perpendicular line to d, which will be eight feet, then draw a line, as seen in the center, from d to a to the outer corner of the plate. These directions, if followed, will give you one-half pitch.

In Fig. 2 we have a roof that is one-fourth pitch. Find the width of the building, which we will say is sixteen feet. One half of it, to the center, would be eight feet. Divide this again, which would be four feet, which should be the length of your perpendicular line from the center. This gives you one-fourth pitch. To find any pitch desired, take the fractional part of the width you wish to make the pitch, and proceed as directed above.

To get your measure, take a smooth board or paper, and draft out your roof, using, say, a scale of three-fourths inch to the foot. This will give you one sixteenth for an inch. By adding the other, or upper, line, the rafter is a little longer, as the bevel increases at the top. Square up on your rafter at the corner of the plate, as seen at b, Fig. 5. Measure to the top whatever you may add above the center line, and get your exact length. When you have made your draft, you can lay on your square or bevel, and get just the slant to cut your rafters.

W. K. LOUGHBOROUGH.