
A VALUABLE accessory to the kitchen sink is made by taking a square of galvanized iron, one side of which is six inches longer than the width of the sink from front to back. Measure along each side three inches from each corner, and mark. Connect these points by lines drawn parallel to the side of the square. Cut out the three-inch squares thus made at the corners. Bend three of the sides upward at right angles along the lines drawn. At the corners solder the ends of the side pieces together. Bend the other side downward. Set the pan upon the sink-board with the side bent downward hanging over the edge of the board and into the sink. This makes a pan in which dishes, when washed, may be scalded and drained without the necessity of leaving them to stand in the water and without spilling the water upon the floor. Leave the pan on the sink-board all the time, and use it in which to place all hot or smutty cooking utensils. The sink and sink-boards are then easily kept white and clean. Your tinker will make the pan for about one dollar.—Woman’s Home Companion.