Cutting and Cracking Glass

50%

Review and Herald Publishing Assn. · Takoma Park Station, Washington, D. C. · Jan 17, 1911

FromThe Youth’s Instructor, Vol. 59, No. 3.

Read the full edition

Cutting and Cracking Glass

GLASS tubing and glass rod must generally be cut to the length required for any particular apparatus. A sharp triangular file is used for this purpose. The stick of tubing or rod to be cut is laid upon a table, and a deep scratch is made with the file at the place where the fracture is to be made. The stick is then grasped with the two hands, one on each side of the mark, while the thumbs are brought together just at the scratch. By pushing with the thumbs, and pulling in the opposite direction with the fingers, the stick is broken squarely at the scratch, just as a stick of candy or a dry twig may be broken. The sharp edges of the fracture should invariably be made smooth, either with a wet file, or by softening the end of the tube or rod in an alcohol-lamp. Tubes or rods of sizes four to eight inclusive may readily be cut in this manner.