The Manufacture of Shrapnel Shells

20%

Review and Herald Publishing Assn. · Takoma Park Station, Washington, D. C. · Aug 21, 1917

FromThe Youth’s Instructor, Vol. 65, No. 34.

Read the full edition

The Manufacture of Shrapnel Shells

A GREAT demand for shells by the European nations in the present great war has induced many machine shops in the United States to manufacture them. The purpose of shrapnel is to produce a terrific explosion at the place where it strikes, so the shells are made of heavy steel and filled with an explosive which tears them into many pieces as it is set off. They also contain quantities of bullets or sharp pieces of steel, which fly in all directions and are very destructive to human life. The shells must be shaped very accurately and weigh just the right amount in order that they may be depended upon to travel alike in the air and reach the right distance. So they require careful workmen and strict inspection, for measurements must be made to one one-thousandth of an inch. In a certain order of four and one-half inch shells, made for England, one out of every 125 was tested by her agent before the lot was accepted. If it behaved well and burst into enough pieces, the 124 others were accepted on the merits of this one, but if not, all were rejected.
The rough steel shells in the form of cylinders open at only one end, are forged at the great steel mills. They are received by the machine shop and perfected, for which several operations are necessary. In the lathe each cylinder is centered, and turned smooth on both inside and outside of the sides and the bottom. In this process it is made of just the right dimensions. It is then taken to the forge. Here the open end is carefully heated by a gas flame, and placed under a heavy trip hammer, which forces the sides in, and makes the opening smaller. This is accomplished by driving a funnel-shaped tool down over the heated end of the shell. Two strokes of the trip hammer make a good beginning, but the shell must be heated again and two more strokes applied before the right shape is obtained. This has reduced the opening to less than one fourth its former area, and given to the front end of the shell a tapering shape.
From here the shell is returned to the machines for further changes. This contracted end is, of course, not perfect as it must be, so it is turned to the right dimensions, both inside and outside, at the lathe. Then threads are cut at the opening, into which is fitted a steel plug, which is also hollow and carries the time fuse used to explode the shrapnel. Now that the shape and size of the shell are perfect, the sides about one-half inch thick and the bottom one inch, half the thickness of the bottom is drilled away on the outside. Then threads are cut in the rim round this shallow hole, and a steel disk which just fits, is screwed in tightly, and the base is again turned smooth at the lathe. This double bottom is a protection to the explosives inside, from possibility of being ignited, when the gun is fired, by any leakage of the flame through possible cracks in the original bottom. Such a result would be disastrous to the gun and to everything near it, so this precaution is taken.
In order to prevent damage to the bore of the gun by scratching, and, at the same time, to secure a close fit, three rings of brass encircle the shell. Shallow grooves are cut for them, the brass rings slipped in place, and then a pressure of several thousand pounds is applied to shrink the rings together and fix them firmly into the grooves. When finished, the rings extend above the surface of the shell three one-thousandths of an inch. The shells must pass a rigid inspection of material and workmanship before they are shipped away. They are not loaded with the explosives and bullets at the machine shop, and a certain secrecy is maintained regarding this process and their destiny. J. NORMAN KIMBLE.