SALT is one of the most common and useful compounds in nature, and is prepared for our use by several methods. It is found in abundance in ocean water, in large deposits underground, and even in some places on the surface of the earth. It is a white crystalline solid composed of two chemical elements: sodium, a soft, gray metal so active that it readily decomposes water; and chlorine, which is a poisonous gas. Both of these elements are harmful to the body when alone, yet when combined to form salt, this product becomes harmless in moderate quantity, and even seems to be necessary to the health of animals living on a vegetarian diet. It is useful also for preserving foods, as it prevents the growth of bacteria ; for curing hides, and in chemistry for the production of chlorine and the soda products. Salt is readily soluble in water, a saturated solution containing 27 per cent of it, and unlike most compounds, it is nearly as soluble in cold as in hot water.
The Letow Ballroom, Cut in Salt, in the Rock-Salt Mines of Wieliczka, Austria-Hungary
Originally, the salt of commerce was obtained from the ocean, or salt water lakes, and it is still so obtained in some countries. Such water is salty because, for centuries, the streams have been dissolving this substance out of the earth and carrying it to the sea, but on returning, through evaporation they must leave the salt behind. Now the ocean water contains three and one-third per cent salt. Men obtain it from the water through evaporation by the sun’s heat, in large open vats. These are built near the shore, and the salty water is stored in the highest one until somewhat concentrated by evaporation, then it is run over into the next one for further reduction, and so on until, in the last pond, the salt becomes dry and may be gathered up. By regulating the time of changing the liquid from one pond to another, some of the other compounds dissolved in the water are removed in part, and the salt is left purer. At best there are some of these present in the final product. It is only in the laboratory that chemically pure salt is made. This will not gather moisture from the air as common table salt does, but remains dry. The presence of calcium (lime) chloride in table salt accounts for its becoming moist and stopping the holes in the shaker. The deposits of salt on the surface of the earth, which are found in some dry sections, came, doubtless, from the evaporation of bodies of salt water.
The best commercial salt, however, is obtained from the underground deposits. These are layers sometimes 250 feet thick and 2,000 to 3,000 feet below the surface. It is here in a hard, crystalline form, called rock salt. Sometimes it is mined like coal, but more often in these deep deposits it is dissolved by water, and forced through to the surface as brine. Wells, similar to oil wells, are sunk into the bed of salt, and within the large casing is placed a smaller iron pipe. Water is forced down the outer pipe under a pressure of perhaps 200 pounds per square inch. It returns up through the inner pipe after having dissolved some salt, against which it presses with enormous force at the bottom of the well. Then this brine stands in large tanks for a time to allow any solid impurities to settle, though it looks as pure and sparkling as water can, when it pours out of the well. Near salt wells, a favorite dish is potatoes boiled in this brine before paring. Sometimes several wells are sunk some distance apart, and operated separately until the enlarging cavities in the salt bed meet and form one large lake of brine. After this, all must be worked in unison or else plugged. The whole subterranean lake bears a pressure sufficient to raise the brine to the surface.
From the large tanks the brine is drawn and evaporated. Several methods are employed to accomplish this; as, the sun’s rays beating upon vats, or fires under open pans, or steam pipes through either an open tank or the vacuum boiler. Only the last method need be described, as the others are self-explanatory. In the vacuum system, the brine is heated by steam pipes running through it, but instead of being in an open vessel, it is in a closed boiler, perhaps ten feet across.
The pressure of the air or steam above the liquid, is so reduced by an air pump that the boiling point of the brine is made as low as 100° F., or very little above our body temperature. This enables the water to evaporate very rapidly. New brine is fed in as needed, and the precipitated salt settles to the funnel-shaped bottom, at the lower extremity of which it is removed. It is then elevated and run into bins to dry if it is to be used only as barrel salt, but if fine table or butter salt is desired, it is artificially dried. First it is rapidly revolved in a centrifugal drier by which most of the moisture is thrown off, then it goes slowly through a hot drum perhaps five feet in diameter and twenty feet long. This drum revolves, and as one end is higher, the salt is moved along toward the lower end. Inside this is a smaller drum heated by steam, over which the salt falls as it drops from the ribs of the revolving drum. It is removed at the lower end perfectly dry, and is elevated to bins there to await the sacking. This is sometimes done by hand and the sacks sewed by hand. Women sew up the tops of the little sacks at the rate of six or eight a minute. Sometimes an automatic machine9
(Concluded on last page)
The Manufacture of Salt
(Concluded from page eight)
is used to place a certain quantity of salt in each sack, then, as an attendant holds it in position, the top is sewed up by a machine. These small sacks are then packed in barrels or bags for shipment.
In the production of this commodity, the United States leads the world. The output in 1914 was nearly thirty-five million barrels. New York, Michigan, Ohio, Kansas, and Louisiana are the chief salt States, though many others scattered over the country produce some also. And nearly every nation in the world has some salt works.