AdventAI

Different Tops — How to Make Them

By Uthai V. Wilcox

From The Youth’s Instructor, Vol. 64, No. 48., November 28, 1916

Of tops there is an endless variety, from the wonderful Chinese ones to the simple whip top that can be purchased for a cent. There are large buildings devoted to the manufacture of tops; but why buy tops when you can make better ones yourself? There is the pleasure of making them, and then you value them more afterward.

The wheels of an old clock will spin, and wooden buttons, with a peg, will spin. Obtain from your mother the largest wooden button she has; sharpen a match, insert through center of button; and whirl them between the thumb and finger on the long end, and you will see them do queer antics. (Fig. 1.) After that try the large red acorn as in Fig. 2.

Figure 1. Figure 2. Figure 3. Figure 4. Figure 6. Fig. 7.
Figure 1. Figure 2. Figure 3. Figure 4. Figure 6. Fig. 7.

Every boy probably has a top like the one in Fig. 3. If not, it is not hard to whittle if one is careful. Did you ever make the whip top? (Fig. 4.) It is the same as Fig. 3 except that it must be square on top, and it does not need the grooves for the string. Make it like the drawing. For a peg you can drive in a short nail and file off the head, leaving a dull point. The whip consists of a round handle a foot long, to which is attached a light piece of braided rope as in Fig. 5. The top is set in motion by the finger, and then is whipped to keep it going. By practice you can make it do various peculiar things at your will by the manner and way you whip it.

Fig. 6 is a humming top. Make this out of a maple roller two and a half inches in diameter. Shape the outside as in the drawing. Bore a hole in the center, then saw it off two and a quarter inches; hollow it out from the top with an augur, then finally burn it out with a hot iron, leaving only a thin shell, which you should carefully scrape. Cover the opening with thin basswood, carefully fitting it on. Bore a hole in the center. Place through this a long hardwood peg, which must project three eighths of an inch at the bottom. Glue carefully the various parts,—peg, top, etc.

After cutting a hole with sharp edges on the side, as in the drawing, make a handle like the drawing in Fig. 7, from hard wood. Spin it this way: The string is wound about the spindle, while the handle is held in the left hand; the right pulls away the string, the handle is at the same time lifted off the spindle. The various tones in the humming of the top will surprise you.

UTHAI V. WILCOX.