AdventAI

The Watch-Guard

By J. Edgar Ross

From The Youth’s Instructor, Vol. L., No. 20, May 15, 1902

To make the watch-guard shown in Fig. 4, six square braids will be required. Four of these should be not less than ten and one-half inches in length; the other two should measure twelve and twenty-five inches respectively. It may not be possible to get hair of sufficient length to make the long braid without splicing. In that case you can make two braids of sufficient aggregate length, and join them when the guard is put together, or you can splice the strands while braiding. The latter plan is the most satisfactory, and, in the long run, the least trouble.

Fig 4.
Fig 4.

When it is evident that it will be necessary to splice some, or all, of the strands in a braid to bring it up to the required length, the strands should be so arranged that the ends will be at least an inch apart. To illustrate: if the longest strand in the braid is sixteen inches in length, the shortest should measure but nine inches, and the remaining six should measure ten, eleven, twelve inches, etc. This done, the braiding is begun in the manner already described, and continued until there is not more than an inch and a half or two inches of the shortest strand remaining. Then take a strand, and place it between the right and left (the odd and even numbers, as shown in the illustration last week), and braid around it. After the first strand has been braided around it, it will keep its place without further attention.

When about three fourths of an inch of the braid has been worked around this strand, it is ready to take the place of the short one. The change can be made at any time when the short strand occupies position five or six (see Fig. 2), but at no other time. All that is necessary is to pull the long strand out into the position of the short one, which will, as the braiding continues, be crowded into the middle of the braid. In this position it is permitted to remain till the braiding has been carried to a point about three fourths of an inch beyond where the change was made. Then whatever remains is cut off, so as to get it out of the way, and not make the braid unnecessarily large.

After the braid is finished, the ends of those strands that have been left projecting may be drawn out slightly, and then cut off. The severed ends of the hair will then sink back into the middle of the braid, where they can not be seen. In this way it is possible to make a braid of any required length without materially weakening its strength, and without showing where the strands have been applied.

Now to return to the watch-guard. Place one end of the long braid between the ends of two of the short ones, allowing the ends to overlap about three fourths of an inch, and wrap the overlapped portion tightly with stout thread. Then sew these ends through and through repeatedly, till there is no danger of their pulling apart; cut off the projecting ends of all three of the braids; and proceed to fasten the two remaining short ones to the other end of the long braid in the same manner. Next take the remaining braid, the twelve-inch one, bring the ends together, and wrap them with thread. This will form a loop, which is to be fastened between the two pairs of short braids, allowing the ends to overlap about three fourths of an inch, as before. At this junction there will be six braids (the doubled one being counted as two), and they must be placed side by side. In other words, the connected part must be six braids wide, and only one braid thick. If they are arranged in any other manner, the guard will not hang as gracefully as it should.

At any place where the braids are joined in this manner, the junction must be well wrapped and thoroughly sewed to prevent the hair from unbraiding, and the braids from pulling apart. The method of covering these joined places will be described next week.

J. EDGAR ROSS.