AdventAI

The Link Chain

By J. Edgar Ross

From The Youth’s Instructor, Vol. L, No. 25, June 19, 1902

THE link chain, though very simple, is neat and serviceable; and if any of the boys of the INSTRUCTOR family wish to make a watch-chain for their own use, I would advise them to try this one.

Make the braids of alternate black and white strands. Each strand should contain about eight hairs. That is rather indefinite so far as it affects the size of the braid; for horsehair varies not a little in size. But eight hairs of the average size will make the strands about right. The finished links, one of which is shown in Fig. 10, should measure about an inch and three fourths in length. To make them, a braid four inches long will be required, as the ends must be slightly overlapped in the middle of the link. A long braid may be cut into the required lengths; but you must remember to tie the braid on each side of the place where it is to be cut, to prevent the strands from unbraiding. No special directions for making this chain will be needed, as each link is made like the illustration, and they are linked together like any other chain. An extra link may be added for a charm, and it may be attached to the watch by springing the ring of the latter, or by putting a loop like that shown in Fig. 9 a few weeks ago on one end of the chain. The other end may be slipped over the vest button.

Fig 10.
Fig 10.

The Heart-Shaped Fob

This attractive little ornament is simple in appearance, but somewhat complicated when you come to put it together. Fig. 11 shows the fob completed, but if no charm is to be worn on it, another heart might be added without making it too long, and the link at the end could be replaced with such a loop as that shown in Fig. 9.

Fig 11.
Fig 11.

To make the heart itself, a braid five inches in length is used. This is doubled, and the ends are sewed together. Now take another piece of braid of the same size, but only an inch long, to make the loop upon which the second heart is hung. Pass this short piece through the loop made with the long braid, and sew the ends even with the ends of the latter, as shown in Fig. 12. Next cover the ends, where they have been sewed together, with needlework. Now take the braid that makes the long loop, and twist it half-way around, so as to bring the side that was on the inside of the loop to the outside. This will bring the small loop to the outside, as shown in Fig. 13. All that is now necessary to finish the heart is to bring the braid together at the point marked a in Fig. 11, and fasten it there with a narrow ring of needlework. The other heart, or hearts, as the case may be, are made in a similar manner; but before sewing the ends of the long braid together, it is passed through the small loop below the first heart. A charm may be attached to the small loop below the last heart.

Fig 12.
Fig 12.
Fig 13.
Fig 13.

In braiding hair for this purpose you must be careful not to let the braid become twisted, or the hearts will not “shape;” and if they are not true when they are first made, no amount of coaxing and twisting will make them so. J. EDGAR ROSS.