A Vest Chain

11%

Review and Herald Publishing Company · Battle Creek, Mich. · May 29, 1902

FromThe Youth’s Instructor, Vol. L, No. 22

Read the full edition

A Vest Chain

A vest chain is more conventional than the watch-guard already described, and is quite as simple to make.
Three eight-strand square braids will be required. The strands used for the braids that are to make the main body of the chain should contain eight or ten hairs each, and the braids should be long enough to make the chain measure from eleven to twelve inches from the end of one loop to the end of the other. The way these braids are to be put together will be seen at a glance by referring to Fig. 7. In the central portion of the chain the upper braid should be the shortest, the middle one three eighths of an inch longer, and the lower one should have another three eighths of an inch added to it. This is necessary in order that the chain may have the appearance of hanging down just as a chain made of links will. Horsehair is so stiff that its own weight is not sufficient to make it hang gracefully.
The short, pendent part of the chain, on which a charm is usually worn, is made of a smaller braid. The strands in it need not contain more than five or six hairs. The one here shown is made of threefold braid, but a double braid would look quite as well. It need not exceed two inches in length. When the ends of the short pieces of braid that make this part of the chain are sewed together , there is sewed to each end a piece of small wire (a pin will do if you haven't a wire small enough), bent in the form shown in Fig. 8. The round loops of these wires are left projecting, one at each end, when the ends of the piece are covered with woven needlework. One of these loops serves to attach the short piece to a similar loop in the main part of the chain (see again Fig. 7), while to the other a charm may be fastened, if one is worn.
Fig 9.
Fig 9.
The chain from which the illustration was made contained, in the chain proper, one long black braid, and a short one made of black and white hairs. The black braid makes both loops, and the upper and lower braids in the central part of the chain. This is rather a pleasing arrangement, but no more so than others would be.
Fig 7. Fig 8.
Fig 7. Fig 8.
Indeed, none of the articles that have been and will be illustrated are given as patterns to be arbitrarily followed. They are intended rather as suggestions, which the reader will adopt, modify, or reject, as suits his taste or requirements.
One of the loops of this chain is intended to be worn on the vest button, while the watch is attached to the other. If the ring of the watch is sprung, and passed through the loop, as recommended for the watch-guard, the chain will stand out instead of hanging like a link chain. For that reason it is best to add a loop such as shown in Fig. 9. This is made of a piece of braid eight inches long. Double it, and sew the ends together. Then wrap twine or thread around the ends that have been sewed till you have a ball about a quarter of an inch in diameter, and sew this securely also. Next cover the ball with woven needlework. Now pass one end of this doubled braid through the loop in the chain, and put a sliding ring of needlework around the doubled portion, as shown at a. It is now ready to put on the watch. Pass the ball, b, through the ring of the watch, and then through the loop, c. Then slide the ring, a, down as close to c as it will go, and it is done. J. EDGAR ROSS.