AdventAI

How Gold-leaf Is Made

By Edward W. Frentz

From The Youth’s Instructor, Vol. LIII, No. 16, April 18, 1905

THE art of the gold-beater is one of the oldest handicrafts in the world, and among those which have changed least. Much of the decoration of Solomon’s temple is believed to have been covered with gold-leaf, hammered to the requisite thinness by hand, as it is to-day.

The gold-beater receives his material not in the form of the sixty-pennyweight ingot in which it is cast, but in the form of a ribbon about an inch wide and twenty-four feet long.

This ribbon is first cut into two hundred squares, and placed in the “cutch,” which is a pile of square pieces of a peculiar paper, part animal and part vegetable in composition, the preparation of which is a secret. The best cutches are made in London. A square of gold is placed between each two leaves, and the whole mass is ready for the first beating.

This is done with an iron hammer, weighing from twelve to seventeen pounds, while the cutch rests upon a granite block, which is supported by a heavy wooden post.

Under the heavy, measured blows of the hammer the sheets of gold begin to stretch or expand until in half or three quarters of an hour, they have reached the edges of the cutch. They are then removed, and with a thin strip of bamboo are cut into quarters, so that the two hundred pieces become eight hundred. Next comes the “shoder,” a collection of eight hundred pieces of skin, four inches square, made from the intestines of cattle. As in the cutch, each piece of gold is placed between two leaves of skin, and bands of parchment or vellum are slipped over the whole pile, to keep it together.

Another beating, this time with a hammer weighing from eight to ten pounds, now follows. This takes about an hour, during which the sheets of gold are all the time perceptibly growing thinner.

The last stage is the “mold,” which, like the cutch and the shoder, is composed of alternate leaves of gold and skin; but the mold is about five inches square and made up of gold-beater’s skin. The preparation of this is a jealously guarded trade secret.

The skin, like that in the shoder, is made from the intestines of the ox. It is translucent, and not unlike rawhide in color. Although it will stand continuous beating without breaking, it will tear like a sheet of thin paper. The making of a single mold requires the intestines of fivep. 3 hundred bullocks. Between each two beatings the skin is rubbed with baked and pulverized gypsum.

A mold contains one thousand sheets. After the second beating the workman takes from the shoder a single leaf of gold at a time, handling it with bamboo pinchers, and, when necessary, smoothing it with a rabbit’s foot. With the strip of bamboo he cuts each sheet into quarters again, so that the original two hundred have now become three thousand two hundred. One shoder, therefore, contains more than enough gold to fill three molds.

The final beating, in the mold, is done with a seven-pound hammer, and requires from three to four hours. By this time the gold-leaf should have expanded again to the edge of the skins, and should be of the requisite thinness, which is determined by holding it up to the light. If it transmits green rays, it is done, and will measure about one two-hundred-and-eighty-thousandth of an inch in thickness.

The hammers used in beating gold are slightly convex on the face. The art of the workman consists in so striking that the gold will always be thinnest in the center. He must pound with evenness all over the square, in order that the sheets of gold may expand without losing their form; but at the same time he must keep the thickest part near the edges, so that when the sheets are finally trimmed to size, the thicker portions may fall in the waste, to be recast. No machinery has ever been devised which will do this successfully.

The tools of the craft are interesting and peculiar. The rabbit’s foot is exceedingly soft, and just oily enough to prevent the gold from sticking, and the bamboo pliers and cutting-slips are the only things with which it is possible to do this delicate work. The gold does not adhere to the fibers of the reed as it does to steel.

The gold-beater performs all his work standing. The use of the heavy hammers in such continuous pounding would, one would think, impose an almost intolerable strain upon the hands and arms. The men say, however, that their arms never ache. The only place where “it catches them” is in the bend of the knee.

The lack of strain upon the arms is accounted for by the fact that the hammer rebounds. It is astonishing, but by no means a rare thing to see a gold-beater change hands while the hammer is in the air, and without losing a stroke.—Edward W. Frentz, in Youth’s Companion.