Model No. 2—Base of Basket
REEDS Nos. 3, 4, and 5 are used in the construction of this basket. The base is similar to the mat previously described. For spokes cut nine pieces of No. 5 reed seven inches long and one piece four inches long. When well softened, split five long ones in the center, and insert the others, placing the short piece in the center, with one end projecting one-fourth inch through the opening. Fig. 1. At a point five feet from one end of one of the longest pieces of well-soaked No. 3 reed separate the fibers by a sharp blow with the awl handle; bend and place the loop as directed for the mat; read carefully the directions there given. Encircle the quarters three times with the pairing weave (same as on the mat), then with the same weave continue twice around, using the spokes in pairs. Notice that the second row divides the first row of pairs. Fig. 2. Pay special attention to filling the corners by bending the spokes well outward, and drawing the weaver toward the center at each stroke, thus forcing it down between the spokes. Still using the same weave, cover the spokes singly until the short weaver is used up. Keep the work round, the spokes evenly spaced, and the weaving close. Do not forget that all changes should be made and the binding off completed at the spoke where the weaving began. With the remaining weaver pass over one spoke and under the next (single weaving), drawing sufficiently tight to make the base slightly convex. The convex side should be toward the worker. Continue until the base is six inches in diameter, splicing and binding off exactly as directed for the mat. Cut surplus spokes as close as possible. Fig. 3.

MRS. E. M. LONG.
(To be concluded)