MATERIAL, reeds Nos. 2, 3, and 4. Base, three and one-half inches in diameter. Spokes of No. 4 reeds, weavers of No. 2. Nineteen stakes of No. 3 reeds, each twelve inches long. Pinch and bend up sharply. Weavers of No. 2. Five rows of triple twist, the first being very tight of course. One inch of single weaving. Stakes should be perfectly straight up to this point. The handle must now be made before the weaving is carried any further. Take a two-yard piece of No. 2 reed; starting at the bottom, pass the ends, one at either side of a spoke, up through upsetting, and single weaving. Fig. 1. Pull the reed up till the loop fits tightly around the spoke.
Take seven one-yard lengths of No. 2 reed, and insert down through single weaving beside the double reed already in. With these nine reeds make a three-strand braid, using three reeds to each strand. Leave the stake on the outside of the braid. Fig. 2. When the braid is as long as desired for the handle, pass two of the reeds down through single weaving and upsetting, around opposite spoke from the first one used, and up again through the upsetting. This firmly secures the handle. Cut the remaining seven reeds just long enough to reach into the upsetting, and insert them beside the other two. This completes the handle.
FIG. 2
Now bend stakes and handle straight outward, and continue single weaving about one and three-fourths inches. The handle must be woven in along with the stake, keeping the stake on the outside.
Bind off same as the base, by passing weaver under last row of weaving at each downward stroke last time around. Cut the stakes to a uniform length, six inches. Make border same as on the first work-basket. E. M. F. LONG.