AdventAI

A Handy Basket

By Mrs. E. M. F. Long

From The Youth’s Instructor, Vol. LIII, No. 12, March 21, 1905

FIG. I
FIG. I

A Handy Basket

By Mrs. E. M. F. Long

Model No. 4

MATERIAL, reeds Nos. 3, 4, 5, and 9. Diameter of base, six inches; top, nine inches; height, six inches. Base is exactly the same as model No. 2. Thirty-eight stakes of No. 4 reed, each twenty-two inches long. Insert one each side of each spoke and use double, as in Model No. 3. Stakes may be bent up sharply from base or rounded as preferred. Rope twist and four rows of triple twist of No. 3 reed form the upset. Four inches of double weaving forms the sides; double weaving is spliced the same as single weaving. Five rows of waling twist complete the weaving. The border of this basket is the same as the braid on the bottom of Model No. 3. When the waling is finished, cut the right stake of each pair close to basket, and follow exactly the directions given for the braid. Tie thread around each of the first four stakes as suggested. Fig. 1 of this article shows how the last four stakes are threaded in to complete the border. When finished, tighten each stake, and cut close.

FIG. 2
FIG. 2
FIG. 3
FIG. 3

For the handle use a piece of No. 9 reed thirty inches long. Soak until sufficiently pliable to make the desired bend over the basket. Slant each end on the inside of handle only. Begin the slant six inches from the end, and graduate to the thinness of paper at the end. Insert one end at the left of any stake, pushing it down through border, waling, siding, and upsetting. Use the awl if necessary, but if properly slanted there will be no difficulty. Insert the other end at the left of the opposite stake. Shape the handle as desired. Select a long No. 3 reed, and soak well. Slip one end between the third and fourth rows of waling at left of one end of handle, and pull through to about the center. Fig. 2. Draw the reeds together quite near the top of basket and over the handle, then, keeping them close together, bring them on around, and push them through under the handle, and bring back over the top. Repeat five times, spacing so that the fifth time brings the winding to the opposite side of basket. Slip the ends between the third and fourth rows of waling at left of handle, and bring them up just as at the starting-point. Fig. 3. Turn and wind back again just as the first time, keeping the second row close to the first. Continue until the spaces are filled, carrying only one reed across the last time if there is not room for two. If the winding reed is not long enough to finish, secure the ends by passing them down through the waling, and start another piece. The exact method of doing this can not well be told. It is only necessary to make it firm and neat. When the handle is closely covered, the winding reeds should be passed down through the waling and cut close. Fig. 4. For service this basket should have two coats of varnish or shellac.

FIG. 4
FIG. 4
AN ACCEPTABLE GIFT
AN ACCEPTABLE GIFT

MRS. E. M. F. LONG.