AdventAI

COLOR-SCREENS AND RAY-FILTERS

By J. Edgar Ross

From The Youth’s Instructor, Vol. 48, No. 27., July 5, 1900

In photographing clouds, flowers, paintings, or anything that has several colors, the use of a color-screen and orthochromatic plates will wonderfully improve the picture. Without the screen, an ordinary plate will make green, yellow, orange, and red of almost the same degree of blackness; while the other colors are rendered almost equally white. The screen and orthochromatic plates tone down this contrast, and give to each plate nearly its true value. Instead of the color-screen a chemical ray-filter is often used for the same purpose.

Both color-screens and ray-filters may be bought at the stock-house; but either can be made with very little trouble. Here is the formula for a color-screen: Dissolve thirty grains of aurantia in one ounce of alcohol; then add one ounce of ether and twenty grains of pyroxaline. Take a thin glass plate (a lantern-slide, cover-glass, or even a spoiled negative that has been cleaned, will do), and pour a small quantity of the solution in the center of it. Tip it from side to side until the plate has been evenly coated over its entire surface. Set it away to dry, and then coat a second and a third plate in the same way. When the plates are dry, two of them should be given a second coat; and when these are dry, one of them may be coated the third time. This will give you screens of three different densities. The denser the screen, the more violet rays will be shut out, and the longer the plate will need to be exposed.

These screens may be used either in front or behind the lens, and may be suspended in any convenient way. They do not usually give as good orthochromatic results as the ray-filter.

A ray-filter consists of an appropriate glass tank filled with a solution of bichromate of potash. A bottle having thin, flat sides entirely free from air-bubbles would answer just as well as a tank made especially for that purpose. I have never been able to find such a bottle when I wanted one, though I have seen them at other times. If you succeed in getting one, all you will need to make a ray-filter will be five cents’ worth of bichromate of potash, and some simple contrivance to attach the bottle to the front of the lens. If you are unable to find a suitable bottle, you can make a tank with very little trouble and almost no expense.

Take four fruit-jar rubbers, and from two of them cut a segment about a quarter of an inch long. With some waterproof cement that will adhere to both rubber and glass, cement the rubbers together with the two uncut ones on the outside. This will give you a rubber ring about three eighths of an inch thick. Cement this ring between two thin glass plates, and your tank is complete. If the corners of the glass are cut so as to make them conform very nearly to the size and shape of the ring, there will be much less danger of breakage than if the plates are left square.

To attach this tank to the lens, take a board about three eighths of an inch thick, and just the size of the plates that make the sides of your tank. Cut a hole in the center large enough to fit snugly over the front of your lens. Do not get the hole too large. It should fit so tightly that there will be no danger of its being knocked off by an accidental jar of the camera. This board is cemented top. 214 one of the glass sides of the tank, which is then filled with the filtering solution. When it has been filled, the opening left by the cut-out sections of the two rubbers may be stopped with a wooden plug.

Make a ten-per-cent solution of bichromate of potash (one ounce of bichromate to ten ounces of water); and when you fill the tank, dilute it to the required density. For dark cumuli clouds a two-per-cent solution is dense enough. Light sirrus clouds will require a five- or six-per-cent solution, with a consequently longer exposure. A bouquet of many-colored flowers should be photographed through an eight- or ten-per-cent solution.

In photographing moving clouds, too long an exposure is apt to cause blurring. Too short an exposure, though it may give sufficient detail, is likely to give the sky an unnatural blackness.

It is best to use orthochromatic, or isochromatic, plates with either the color-screen or the ray-filter. These plates are especially sensitive to yellow and orange light, and consequently they give the color values more nearly correct than do the ordinary plates.

Some manufacturers advertise that color-screens are not needed with their “ortho,” or “iso,” plates, but do not believe such a statement. A common plate, with a color-screen or a ray-filter, will give much truer monochromatic results than the best orthochromatic plates will give without one.

J. EDGAR ROSS.