PROBABLY the smallest screws are those turned out in a watch factory. They are cut from steel wire by a machine, but, as the chips fall from the knife, one is tempted to observe that the operator is amusing himself, inasmuch as no screws can be seen. Yet, at every third operation of the machine, a screw is duly completed. The fourth jewel-wheel screw is next to invisible, and to the naked eye it resembles a speck of dust. With a glass, it may be seen to be a small screw, and some calculation reveals the fact that it has two hundred sixty threads to the inch. It takes a very powerful glass to observe these threads. These screws are said to be but four thousandths of an inch in diameter, and the heads are double in size. It has been estimated that an ordinary thimble could contain one hundred thousand of them. Quite a number of new jewel settings have been added to the movements of first-class watches during the last ten years. These new jewels have created an added demand for expert jewel setters. The term jewel in a watch movement is to be taken literally. The small precious stones are drilled to receive the pinions or axles of the wheels, the object being to provide a bearing that will not corrode and will not wear away easily. The garnet is the least valuable of these jewel settings, but some of the minute sapphires and rubies employed in the bearings of a watch are quite good enough for the setting of a ring. For the most part, however, these fragments of precious stones are off color, the sapphire especially pale to insignificance, but at the same time harder and better for watch jewels because of this light color. Occasionally a ruby jewel burns red in one of the neat little envelopes in which they come from Switzerland, five hundred or one thousand in a lot. Each stone is shaped to a circle and bored through9 the center, each boring being just a little less than the diameter of the pinion used in the factory where it is finally to be placed in the upper or the lower plate of a watch. The immediate setting for the watch jewel is a minute cylinder, brassy in appearance, but really of soft gold composition. Before the jewel gets to the setter, it has been put into a lathe, and by means of a minute steel point covered with diamond-dust and oil, the center has been enlarged to fit the steel pinion which shall be housed in it. In the hands of the setter the cylinder is put into a lathe. With a moistened finger the jewel is picked up and placed inside the cylinder as it rests on the tip of the revolving lathe shaft. With a pointed tool the setter presses against the revolving cylinder edge, forcing the soft metal to overlap and close upon the sapphire or ruby till it is embedded firmly in the metal cushion; then a pressure upon a follower at the other end of the lathe brings a cutter to bear upon the metal circumference, turning it to the exact size of the jewel hole in the plate of the watch, with the hole in the center of the jewel exactly in the center of the metal setting.—Harper's Weekly.