How to Use Common Tools
By J. C. Beard
PROBABLY almost every one at times has had need to know how to cut glass when a glazier or a glazier’s diamond-pointed glass-cutting instrument was not to be had. Even if the instrument referred to is at hand, a novice in its use would better not attempt to employ it, for it requires skill and experience to handle it properly. There is always considerable danger of ruining it, and it is a very expensive tool. Fortunately, it can be dispensed with, and glass can be cut almost as easily without it as with it, if a little more time is given to the operation. Suppose, for instance, it is required to cut a circular piece from a pane of glass. Cut out of rather thick paper a circle of the size required. Paste it on the glass. Take a piece of pointed wire or a knitting needle, one end of which is inserted in a large cork, or use a long pipe stem, as slender a one as you can get. Those on what are called church warden’s pipes are the best for the purpose. Heat the wire or knitting-needle red hot. Also heat the glass, but be sure not to do it so suddenly as to break it. Wet the sharpened end of a lead pencil and touch the glass at some point on the circle. If the glass has been sufficiently heated, a tiny crack will start. Let the glass cool, and then hold your wire, your knitting-needle, or your pipe stem against the glass, near where the crack begins, but not directly on it. The glass will immediately crack more, making the original crack extend from the point where it has started until it reaches your cutter. Move the cutter around the edge of the paper until you have completed the circle. A glass tube or a bottle can be cut in the same way. A hole can be filed in the shoulder or in any other part of a bottle with a three-cornered file wetted with turpentine and camphor. If the aperture is required to be circular, it can be shaped afterward by a round file. If a flat piece of glass is to be perforated, a rather complicated and decidedly expensive apparatus is commonly used, involving the use of tools especially manufactured for the purpose. The following process will be found quite as effective, and certainly cheap enough to be within the power of any one to use:— Sharpen an ordinary awl, heat it in the flame of a lamp or a gas jet to a bright cherry red, and then plunge it immediately into a lump of beeswax. This operation will harden the drill sufficiently for your purpose without making it too brittle. Fold up a newspaper, and place it on your work-table upon a flat piece of wood somewhat larger than the glass you propose to perforate. Lay the glass upon the paper. Put over this a bridge consisting of a piece of wood about an inch thick. To each end of this is fastened a small block of sufficient thickness to raise the piece of wood to which they are attached a bit above the glass. The bridge must be fastened securely to the piece of wood upon which it and the glass rest. Bore a hole in the bridge directly over the spot where you wish to perforate the glass. This hole is to guide the drill. Keep the drill wet with turpentine or with turpentine and camphor, and pour on this a little No. 4 emery. You can buy enough for five or ten cents to last you a lifetime for such purposes. Before beginning to drill, however, be careful to drive wedges between the glass and the bridge, so that the glass is immovably fastened in place. It is much better, unless the glass is quite thin, to turn it over and drill from opposite sides. Now put your drill into the hole in the bridge, turn it first partly around to the left and then to the right, and you will soon have your glass perforated. Be careful to keep your drill well supplied with turpentine and with emery, and do not press down upon it so heavily as to crack the glass. Afterward, by the use of a file, the hole can be enlarged and shaped as required. The edges of glass thus cut can be smoothed off by the use of the same instrument.—J. C. Beard.